SeaSTAR 3510LR Bedienungsanleitung PDF herunterladen (Seite 21)

3510LR USER MANUAL

Issue 1.0 11/04

Cable Installation

• Cables must be correctly installed for optimum system operation.

Therefore, the following should be noted:

• Do not route an L-Band receiver remote antenna cable with the cabling of

any other radio system. This may cause interference between both

systems.

• If at all possible, do not run L-Band receiver antenna cables parallel to

other radio system cabling closer than 30 centimetres.

• If cables must cross, ensure that they cross at an angle of

90°. This minimises the possibility of interference.

• As far as is practicable, ensure that cables and I/O connectors are unique

and fit only in their allocated location.

• Avoid routing cables along-side power generator cabling and other high

electrical noise sources. This can cause interference.

• Do not kink or force cables into sharp bends that may damage the cables

and cause system failure.

• After installation, ensure that excess cable in looped and clamped or tied

safely away from any control cables, fuel lines, hydraulic lines or moving

parts.

When stowing over length cables, form loops not less than

150mm minimum cable bend radius.

• Cable routing must avoid high temperature exposure

(e.g. exhaust manifold).

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 49 50

Keine Kommentare

SeaSTAR 3510LR Bedienungsanleitung Seite 21