SeaSTAR 3510LR Bedienungsanleitung PDF herunterladen (Seite 16)

SeaSTAR 3510LR USER MANUAL

Issue 1.0 11/04

Antenna

Antenna connection is made via a 5 metre RG58 low loss cable,

which is terminated with a standard TNC 50-ohm male connector.

If two antennae are supplied, each antenna will have its own cable.

An antenna unit has an internal LNA (low noise amplifier) which is typically

the antenna socket on the rear panel. Therefore, care must be taken not to

connect or disconnect an antenna when power is on.

Data

The Data port is a standard DB9 female socket. The external GPS is plugged into

this port. A laptop computer may also be plugged into the Data Port to view the

RTCM output.

Pin Number Signal

2 TXD2

3 RXD2

5 GND2

Table 1. Data Port Pin Assignment

A special Data cable is supplied, terminated as shown in the Figure below.

DB9 Male

Pin number

2 metre cable

DB9 Female

Pin number

2 --------------- 2

3 --------------- 3

5 --------------- 5

Warning: Do NOT use standard RS232 cables.

Command

The Command port is a standard DB9 female socket. Receiver configuration

(OmniSTAR 3500L board) can be carried out via this port by plugging in a laptop

computer with ‘Toolkit’ software.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 49 50

Keine Kommentare

SeaSTAR 3510LR Bedienungsanleitung Seite 16